The Jensen RV Stereo part # JWM60A as with all of our stereos which have Bluetooth only allow for input connections like pairing a mobile device to access a playlist. It would not allow for you to playback audio via a set of Bluetooth speakers or headphones for example. This will be the case for pretty much all stereos which have Bluetooth. view full answer...
When wiring the Wireless Charging Dock for Furrion LIT Portable Bluetooth Speaker # FBS012NCU, you'll just want to connect it to a good 12v power supply and ground it properly. So a standard wire cap connector would work just fine. view full answer...
I confirmed with Furrion that the Furrion Bluetooth Stereo, # DV3100, will only connect through Bluetooth with devices are the source of the streaming media like an iPhone or an Android device.
The stereo cannot be connected to a peripheral device like a Bluetooth speaker. The stereo can only receive a Bluetooth signal and it cannot send the signal out to another unit. view full answer...
In regards to the Jensen RV Stereo part # JWM45, there are two zones each of which can support two speakers for a total of four. The zones can be cycled through using the zone buttons on the faceplate or wireless remote. It will not hurt the system to only hook up one zone. view full answer...
Assuming the noise your camera picks up is ground related when the RV is running (it most likely is) then yes, the Quest Ground Loop Isolator # 292-100643 will reduce that noise. view full answer...
The side camera (or any of your cameras) can be paired with more than one monitor but not at the same time. You cannot pair your camera(s) to both your 7 inch and your 5 inch monitors. It's basically the same concept as trying to pair two separate phones to a Bluetooth device like a speaker for example - only one can be paired at one time.
So, the only solution is to add a dedicated "doggy cam" to use with one of your Vision S monitors. For that you would want the Furrion Vision S Wireless... view full answer...